TeamViewer Remote comes with built-in Wake-on-LAN support. Providing that the computer you want to control meets certain configuration requirements, WoL allows you to wake it up from another device. This feature can be useful for remotely turning on a computer and saving energy by avoiding keeping it constantly powered on. Wake-on-LAN (WoL) is a computer industry standard protocol for remotely reactivating a computer from a low-power or powered-down mode. In this guide, we have seen how to configure Wake-on-LAN on a Debian GNU/Linux system, SysLinuxOS, using systemd. The computer should start up after receiving the magic packet. $ sudo apt-get install wakeonlan etherwake To test Wake-on-LAN, send a magic packet over the network using a tool like wakeonlan or etherwake: $ sudo tee /etc/systemd/network/10-enp3s0.link is the MAC address of the computer’s network card.ĭetermine the MAC address of the target device you want to wake up: Step 2 – Configure systemd to enable Wake-on-LAN at boot The letter “ d” means that WOL on the card is disabled. Supported pause frame use: Symmetric Receive-onlyĪdvertised link modes: 10baseT/Half 10baseT/FullĪdvertised pause frame use: Symmetric Receive-only Supported link modes: 10baseT/Half 10baseT/Full If the command returns a line with “ Wake-on: d“, it means that the network card supports WoL. Where is the name of the network interface (e.g., eth0 or enp3s0). You can do this by running the following command: In this guide, we will see how to configure Wake-on-LAN on a Debian-based system, SysLinuxOS, using systemd.īefore proceeding, it’s important to check that the computer’s network device supports Wake-on-LAN. To use this feature, you need to enable WoL support in the BIOS/UEFI and configure the operating system to detect and respond to magic packets. Wake-on-LAN (WoL) is a feature that allows you to turn on a computer remotely by sending a magic packet over the network. How to configure Wake-on-LAN using systemd
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |